Proper Hand Position - Facom NS.3500G Notice Originale

Charging: To charge the unit, connect the USB charging cable into the charging
port (A, Fig. 2) on the unit and then plug it in to an appropriate USB port. An AC
adaptor can also be used to charge the unit via a standard electrical outlet.
Longest life and best performance can be obtained if the battery pack is charged
when the air temperature is between 18° and 24 °C.
DO NOT charge the battery pack in an air temperature below +4.5 °C, or above
+40.5 °C. This is important and will prevent serious damage to the battery pack.
NOTE: While the unit is charging, the LED Light will blink continuously indicating
that the charging process has started. The completion of charge will be indicated
by the LED light remaining ON continuously in a dimmed state. The battery pack
is fully charged and may be used at this time or left in the charger. NOTE: To
ensure maximum performance and life of lithium-ion battery packs, charge the
battery pack fully before first use. The LED Light will fully recharge in 4 hours or
less.
CAUTION: Do not stare into LED light. Serious eye injury could result.
There are two LED lights located around the square drive. The LED lights are
activated when the trigger switch is depressed.
- The LED lights will turn off after being illuminated for 20 seconds.
NOTE: The LED Lights are for lighting the immediate work surface and are not intended to be used as a flashlight.
ADAPTOR STATUS INDICATOR

PROPER HAND POSITION

Warning: To reduce the risk of serious personal injury, ALWAYS use proper hand position as shown.
Warning: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a sudden
reaction.
SERVICE
• Tool service must be performed by qualified repair personnel, using only FACOM authorized, identical replacement parts. Use
only lubricants recommended by FACOM.
MAINTENANCE
Lubrication
Air tools require lubrication throughout the lifetime of the tools.
This power tool uses compressed air as a power source. The compressed air contains moisture that will rust the components
inside of the tools, therefore lubrication is required daily. Failure to lubricate the air tool properly will dramatically shorten the life of the
tool and will void the warranty
CAUTION: This air tool requires lubrication BEFORE initial use, also before and after each additional use.
To Lubricate the Air Tool Manually:
1. Disconnect the tool from the air supply source, place the air inlet face up.
2. Depress the trigger and place about 0.15 to 0.25 ml of air tool oil into the air inlet.
NOTE: Use SAE #10 weight oil if air tool oil is not available.
NU-NS.3500G-NS.3100G-NS.2500G_0118.indd 13
Fig. 3
State of charge
charging
fully charged
WARNING
Fig. 2
_ _ _
________
13
A
Fig. 4
08/01/2018 08:10:26