Cycle Selection Chart; Canceling A Cycle; Changing A Cycle Or Setting; Adding Items During A Cycle - Roper Rud1000 Guide D'utilisation Et D'entretien

Cycle Selection Chart

Select the wash cycle. If the door is latched, you will hear
the cycles start and stop as the Cycle Control knob passes
each cycle mark. This is normal and does not hurt the
dishwasher. If you prefer, you can set the Cycle Control
knob with the door unlatched.
NOTE: Use the Energy-Saver Dry option with the Rinse &
Hold cycle (on some models).
Models with a rocker switch:
Turn the Cycle Control knob to the desired cycle.
Models with 5 pads:
Press the desired cycle. Turn the Cycle Control knob to the
desired cycle. To use Rinse & Hold, press any cycle and
turn the Cycle Control knob to Rinse & Hold.
A " " shows what steps are in each cycle.
Use this cycle for hard-to-clean, heavily soiled
pots, pans, casseroles, regular tableware, and
POTS &
harder than normal water conditions.
PANS
Use both detergent dispenser sections.
Pre- Rinse Rinse Main
Wash Wash
Use this cycle for loads with normal amounts
WASH
of food soil. (The energy usage label is based
or
on this cycle.)
NORMAL
WASH
Use both detergent dispenser sections.
Pre- Rinse Rinse Main
Wash Wash
Use this cycle for pre-rinsed or lightly soiled
loads. No extra heat is added to the main
LIGHT
wash.
WASH
Use covered detergent dispenser section.
Pre- Rinse Rinse Main
Wash Wash
12
Rinse Final Dry Time
Rinse (min)
98
Rinse Final Dry Time
Rinse (min)
90
Rinse Final Dry Time
Rinse (min)
85
Use this rinse cycle for rinsing dishes, glasses,
and silverware that will not be washed right
RINSE
away.
& HOLD
Do not use detergent with the rinse cycle.
Pre- Rinse Rinse
Wash

Canceling a Cycle

You can cancel a cycle at any time.
1. Turn the Cycle Control knob slowly clockwise until you
hear water draining. Let the dishwasher drain
completely.
2. Open the door.
3. Turn the Cycle Control knob to OFF.

Changing a Cycle or Setting

If you dishwasher has more than one wash cycle, you can
change a cycle anytime during a cycle.
1. Lift the door latch to stop the cycle.
Water
Usage
2. Turn the Cycle Control knob clockwise.
(gal/L)
3. Check the detergent dispensers. They must be filled
8.6/32.7
properly for the new cycle.
NOTE: Turning the Cycle Control knob can cause the
covered Detergent Dispenser section to open and
release the detergent. Check the covered section if the
cycle uses detergent in both sections.
4. Close the door firmly until it latches. The dishwasher
starts a new cycle.
Water
Usage
(gal/L)
7.2/27.2

Adding Items During a Cycle

You can add an item anytime before the main wash starts,
or the Cycle Control knob reaches Light Wash (on some
models).
1. Lift up the door latch to stop the cycle. Wait for the
spraying action to stop before opening the door.
Water
2. Open the door and add the item.
Usage
(gal/L)
3. Close the door, but do not latch it. Wait 30 seconds for
5.7/21.8
the air in the dishwasher to warm up. This reduces the
amount of moisture escaping from the vent when
restarting a cycle.
4. Close the door firmly until it latches. The dishwasher
resumes the cycle.
Main Rinse Final Dry
Wash Rinse
Time Water
Usage
(min)
(gal/L)
20 2.9/10.9