Publicité
w
e
r
4) Reinstall the filter element in the cup.
t
Make sure the O-ring in position in
the cup. Insert the cup and O-ring into
q
the filter housing. Screw the ring nut
onto the filter housing until the ring is
lightly seated.
5) Tighten the ring nut approximately an
additional 1/4 turn until ring nut is
tight. Align one of the four larger ring
207052
nut tabs into the slot of the locking tab.
Install the locking tab bolt and tighten.
6) Run the engine and check the filter
and lines for leaks.
1 Filter element
2 O-ring
3 Filter cup
4 Ring nut
5 Filter housing
NOTE:
If any water is in the fuel, the red ring in
the fuel filter unit will float. If so, remove
the cup and drain the water.
EMK54110
ADJUSTING IDLING SPEED
w
8 Do not touch or remove electrical parts
when starting or during operation.
8 Keep hands, hair and clothes away
from flywheel and other rotating parts
while engine is running.
cC
This procedure must be performed while
the outboard motor is in the water. A
flushing attachment or test tank can be
used.
4-13
GB
Publicité
Chapitres
