Burner Tubes Cleaning Or Replacement - Weber GENESIS 320 Guide De L'utilisateur

BURNER TUBES CLEANING OR REPLACEMENT

You will need: Phillips screwdriver and flathead screwdriver .
A) Your Weber gas barbecue must be OFF and cool .
®
B) Turn gas OFF at source .
C) Remove cookbox components - warming rack, grates and Flavorizer
deflectors do not need to be removed .)
Control Panel Removal
D) To remove control panel:
a) Remove control knobs, igniter button, igniter retention nut, and battery (1) .
b) Remove screws from wind deflector (2) located underneath the control panel
with a Phillips screwdriver .
c) Tilt end of wind deflector down and slide away to remove (3) .
d) Remove igniter module from control panel (4) and remove all four wires from
module .
e) Remove screws from underside of control panel with Phillips screwdriver (5) .
f) Lift control panel up slightly, tilt up front edge and gently lift up and away (6) .
24
MAINTENANCE
!
bars . (Heat
®
3
1
2
5
4
6