Installation Instructions - Danby DWC114BLSDD Manuel Du Propriétaire

Installation Instructions - Door Swing Reversal
WARNING! WARNING!
Excessive Weight Hazard
Use two or more people when moving
the wine cooler.
1 Rubber cover
2 Screws
3 Decorative cover
4 Screws
5 Top hinge
6 Decorative nail
7 Screws
8 Lower hinge
9 Cabinet leg
10 Extrusion-board
of lamp switch
11 Screws
12 Decorative nail
1 Close the door and take out rubber cover (1), unscrew two screws (2) and remove
decorative cover (3). (Fig.1)
2 Unscrew screws (4) and take out top hinge (5), then remove the door. (Fig. 2)
3 Put door safety, unscrew decorative nail (12) and take out 2 screws (11) at bottom,
pull out extrusion-board of lamp switch (10) and fix it at top of door. Block holes at
bottom of door with spare decorative nail. (Fig. 5)
4 Pull out decorative nail (6) from left top of cabinet. (Fig.3)
5 Unscrew 3 screws (7) from right bottom of cabinet and remove lower hinge (8). (Fig.4)
6 Pull out cabinet leg (9) from left bottom of cabinet and fix it onto right bottom of
cabinet. (Fig.4)
7 Fix the lower hinge (8) onto left bottom of cabinet with screws (7). (Fig. 4)
8 The door revolves 180 degrees, put lower door axis to aim at lower hinge (8) and
install the door onto lower hinge (8), then close the door carefully. (Fig.5)
9 Fix top hinge (5) onto left top of cabinet with screws (4), adjust door and install
decorative cover (3) and rubber cover (1). (Fig.6)
10. Block 3 screw holes at right top of cabinet with spare decorative nail.
TOOLS REQUIRED TOOLS REQUIRED
Phillips #2 screwdriver and an adjustable wrench.
8