Electronic Oven Control; Electronic Control Pads; Oven Display; Quickset Pads - Jenn-Air JGS8750 Guide D'utilisation Et D'entretien

Models JGS8850 and JGS8860
H
I
Model JGS8750
G

Electronic Control Pads

When pressing any control pad function on the Electronic Oven
Control, use the pad of your finger to press the desired function.
Hold down the pad a few seconds, or until the desired function
appears in the display.

Oven Display

When power is supplied to the range or after a power
interruption, "12:00" and "POWER LOSS" will be displayed.
Press CANCEL to clear "POWER LOSS."
When the oven is in use, the display shows the time of day,
temperature, and oven setting.
When the oven is not is use, the display shows the time of day.
When using the Timer, for settings of 1 to 59 minutes, the display
will count down in minutes and seconds. For settings of 1 hour or
more, the display will count down hours and minutes.
8

ELECTRONIC OVEN CONTROL

A B C B D
N
J K L M
A. Bake F. Timer 2
B. Favorites G. Number pads
C. Setup H. Broil
D. Timer 1 I. Convect
E. Display J. Rapid preheat
A B B
C
K
H I J
A. Bake E. Timer 2
B. Favorites F. Number pads
C. Timer 1 G. Broil
D. Display H. More options
E F
O P M Q
K. More options P. Cancel
L. Clean Q. Back
M. Quickset pads R. Lock
N. Warm drawer S. Enter
O. Oven light
E
D
N
L M J
I. Clean M. Cancel
J. Quickset pads N. Back
K. Setup O. Lock
L. Oven light P. Enter

Quickset Pads

Quickset pads are located on each side of the display window
and are used to select the desired function or option in the
display window. To select the option or function, press the
Quickset pad next to the word.
If you need to back out of a function or option in the display,
press the BACK pad. When your programming is complete, press
the ENTER pad or wait 4 seconds and the function will start
automatically.
Up arrows indicate additional screens with additional options.
Press the QUICKSET pads next to the arrows to scroll through
the display.
IMPORTANT: Four seconds after entering the function, option,
number or letter, the function will automatically be entered. If
more than 30 seconds elapse between steps in programming,
the function will be canceled and the display will return to the
previous display.
G
R S
F
O P