Greencut GLM560L-16 Manuel D'utilisation page 56

56
INSTALLING THE GRASS CATCHER (FOR REAR BAGGING OPERATION)
NOTE: When using the grass catcher (D),
do not install the mulching plug.
• Remove battery.
• Lift the rear discharge door (N).
• Lift the grass catcher (D) by its handle and place under
the rear discharge door (N) so that the hooks on the
grass catcher are seated onto the slots on the mower
housing.
• Release the rear discharge door (N).
• Reinstall battery when you are ready to mow.
TO INSTALL BATTERY
ATTENTION: Always remove battery from your tool when you are assembling parts, making
adjustments, cleaning, or when not in use. Removing battery will prevent accidental starting that
could cause serious personal injury.
• Raise the battery cover (J).
• Place the battery in the mower.
• Align raised ribs on battery with grooves in the mower's
battery port.
• Push down into battery compartment until the battery
clicks into place.
• Lower the battery cover.
ATTENTION: Make sure the latch on top
of the battery release button snaps in
place and the battery is fully seated and
secure in the mower's battery port before
beginning operation. Failure to securely
seat the battery could cause the battery to
fall out, resulting in serious personal injury.
To remove the battery:
• Press the battery release button (O) on the mower. This
will cause the battery to raise out of the tool slightly.
• Raise the battery cover.
• Remove battery from the mower.
NOTE: Some units are sold without a battery or charger, for compatibility refer to the Technical
Features Chart.
D
J
O
N