Maintenance; Filtering System - ETNA VWV242WIT Mode D'emploi

MAINTENANCE

Filtering system

The filtering system in the base of the wash cabinet retains coarse debris from the washing
cycle. The collected coarse debris may cause the filters to clog. Check the condition of the filters
regularly and clean them if necessary under running water. Follow the steps below to clean the
filters in the wash cabinet.
Note: Pictures are only for reference. The models of the filtering system and spray arms
can be different.
1. Hold the coarse filter and rotate it anticlockwise to unlock the filter. Lift the filter upwards
and out of the dishwasher.
2. The fine filter can be pulled off the bottom of the filter assembly. The coarse filter can be
detached from the main filter by gently squeezing the tabs at the top and pulling it away.
3. Larger food remnants can be cleaned by rinsing the filter under running water.
For a more thorough clean, use a soft cleaning brush.
4. Reassemble the filters in the reverse order of the dissasembly, replace the filter insert, and
rotate clockwise to the close arrow.
Warning! Do not over tighten the filters. Put the filters back in sequence securely,
otherwise coarse debris could get into the system and cause a blockage. NEVER use
the dishwasher without filters in place. Improper replacement of the filter may reduce
the performance level of the appliance and damage dishes and utensils.
EN 20
Open
Open Open
Coarse filter
Main filter
Fine filter
Coarse filter
Main filter
Fine filter