Bosch AGS 7,2 LI Notice Originale page 25

Operation
Initial Operation
Switching On (see figure E)
Dis-engage the safety lock 3 by moving the
button as shown.
Then press the On/Off switch 7 and keep it
pressed.
Switching Off
Release the On/Off switch 7.
Engage the safety lock 3 by moving the button
as shown.
Battery Charge-control Indication
The battery charge-control indicator 2 indicates
the charge condition of the battery for a few sec-
onds when the On/Off switch 7 is pressed
through halfway of fully.
LED
Continuous lighting, green
Flashing light, green
Flashing light, red
Continuous lighting, red
Working Advice
Hold the garden product away from your-
self. Stand in a secure and stable position.
For more tips on cutting please refer to
website www.bosch-pt.com.
Anti Blocking (shrub shear only)
The garden product has a patented feature
which works as follows:
If the blade stalls on a tough material, the load
of the motor increases. The intelligent micro-
electronics senses this overload condition and
repeatedly reverses the motor, in order to pre-
vent stalling and to cut the material through.
This audible reversing cut action continues for
up to 3 s.
After cutting through, the garden product con-
tinues in its normal mode, or in case the over-
load condition continues the blades automati-
Bosch Power Tools
cally stop in the open position (e. g. in case a
piece of metal fence accidentally blocks the gar-
den product).
Cutting Hedges (shrub shear only)
Before cutting check the hedge for foreign ob-
jects e. g. wire fences.
Cut stems up to 8 mm in thickness. When cut-
ting, move steadily along the line of cut, so that
stems are fed directly into the cutter blades.
The double edge of the cutting blade enables
cutting to either direction, or with a side to side
motion.
After use replace the blade transport guard.
Recommended times
– Cut hedges with deciduous leaves in June
and October.
– Cut evergreen hedges in April and August.
– Cut conifer and other fast growing shrubs ap-
prox. every six weeks from May onwards.
Capacity
Edging (grass shear only) (see figure D)
≥35%
Guide the garden product along the edge of the
lawn. Do not allow the blade to contact paved
15 – 35%
surfaces, stones or garden walls, since this will
5 – 15%
wear the blade rapidly.
≤5%
For larger lawn it is advisable to use the pole
cart (available as an accessory or supplier with
"grass shear & pole cart" set).
After use replace the blade transport guard.
Maintenance and Service
Maintenance and Cleaning
Warning! Switch off before adjusting or
cleaning. The blades continue to move for a
few seconds after the garden product is
switched off.
Caution! Do not touch the moving blades.
For safe and proper working, always keep
the garden product clean.
Always wear protective gloves when using,
adjusting or cleaning the garden product.
English | 25
F 016 L70 608 | (27.1.10)