Kicker Bullfrog Série Manuel D'utilisation page 7

Bluetooth
The KICKER Bullfrog supports audio input via Bluetooth transfer protocol.
It will remember and auto-connect with up to 5 audio devices. Use a
software reset to wipe the auto-connect list, or pair more devices to bump
the last one off.
Enter Pairing mode by performing a long press (1 second) of the PAIR button
while the speaker is powered on. The Blue source LED will fl ash while in pairing
mode for up to 2 minutes, then time-out. You may also exit pairing mode by
pressing the PAIR button.
When the Bullfrog enters Bluetooth mode, it will automatically begin to search
for and connect with the last connected device. If that device is not found, it
will continue to search for the other saved connections until a connection is
established.
When in Bluetooth Pairing mode, the Bullfrog will display as "BF100 KICKER" on
your Bluetooth device.
Double-Kick Mode:
Double-Kick allows you to play your audio through two Bullfrogs. One Bullfrog, the Primary, will
broadcast the audio to the Secondary Bullfrog. Audio and EQ settings applied by the Primary
Bullfrog, or KICKER Connect app, will be mirrored on the Secondary Bullfrog. Double-Kick
mode is compatible with all audio input sources. You may enter Double-Kick mode by using
the KICKER Connect app, or manually with the following button sequence.
1. Pair Bluetooth device with Primary Bullfrog
2. Setup Primary Speaker
Press & Hold PAIR and '+' on
Primary Bullfrog. The battery
LEDs will indicate
with an inside-out pattern.
Primary
When successful, the Primary Bullfrog should have a solid input source LED. The Secondary
Bullfrog should have all input source LEDs solid. Any volume changes made on one Bullfrog
will effect the other. Press the PAIR button, or turn the Bullfrog off, to exit Double-Kick mode.
6
2.
1S
Primary mode
3. Setup Secondary Speaker
Press & Hold PAIR and '–' on
Secondary Bullfrog. The battery
LEDs will indicate Secondary
mode with an outside-in pattern.
1S
=
3.
1S
Secondary