Installation - Zanussi ZEV6340XBA Notice D'utilisation

If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes on.

Installation

WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
Assembly
min.
500mm
www.zanussi.com
min.
50mm
Make sure, you operated the hob correctly. If
not the servicing by a service technician or
dealer will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee are
in the guarantee booklet.
Connection cable
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
the following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
R 5mm
+1
490 mm
min.
55mm
+1
560 mm
23