KOBE Brillia Série Manuel D'installation Et Mode D'emploi page 11

-
Align and secure Top Vent Cover {E} and 3-1/4" x
10" Vent Cover (removed from rear exhaust) using
14 screws (13 screws taken from 6" exhaust.
(Figure 5)
-
Attach the 3-1/4" x 10" Exhaust {D} to rear exhaust
(located inside hood) using 10 screws taken from
rear vent cover. (Figure 6)
Hood Installation
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power in
an electric range at the main electrical box. SHUT
OFF THE GAS BEFORE MOVING A GAS RANGE.
And use a protective covering to protect cooktop
and/or countertop from damage.
5. Remove the baffle filters/stainless steel spacers if
necessary; arrange the electrical wires to run
through the 1" diameter hole on the top or the rear of
the hood.
6. Using references on Table 1 and measurements on
page 18, center the hood in place beneath the
cabinet and flush with the front of the cabinet.
7. Draw electrical wires through cabinet access
opening.
8. Use electrical drill to remove the knockout holes on
top of the range hood.
9. Place screw (provided) into the exact center of each
knockout hole. Make sure all screws are in place
before tightening screws.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Wiring to Power Supply
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power in
an electric range at the main electrical box. SHUT
OFF THE GAS BEFORE MOVING A GAS RANGE.
RISK OF ELECTRICAL SHOCK.
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE WITH
ALL APPLICABLE
ELECTRICAL CODES.
WIRES, SWITCH POWER OFF AT SERVICE PANEL
AND LOCK SERVICE PANEL TO PREVENT POWER
FROM BEING SWITCHED ON ACCIDENTALLY.
-
If hood is operating normally, connect three wires
(black, white and green) to house wires and cap
with wire connectors.
-
Store wires in the wiring box.
NATIONAL AND
BEFORE CONNECTING
Figure 5
Figure 6
LOCAL
9