KOBE Brillia Serie Manuel D'installation Et Mode D'emploi page 9

Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE
VENT OPENING.
•
Decide the location of the venting pipe from the hood
to the outside (Figure 1).
•
A straight, short vent run will allow the hood to
perform more efficiently.
•
Try to avoid as many transitions, elbows, and long
runs as possible. Transitions, elbows, and/or long
runs may reduce the performance of the hood.
•
Temporarily wire the hood to test for proper
operation before installing.
•
Important: Peel protective film off the hood and
product covers, if any.
•
Use duct tape to seal the joints between pipe
sections.
Island Installation
CAUTION: USE HAND TOOLS ONLY. DO NOT
OVER TIGHTEN SCREWS.
DAMAGE TO THE HOOD.
CAUTION: If moving the cooking range is
necessary to install the hood, turn off the
power in an electric range at the main electrical
box. SHUT OFF THE GAS BEFORE MOVING A
GAS RANGE.
And use a protective covering to protect cooktop
and/or countertop from damage.
1. Mark centerline of cook top or range on ceiling. Use
centerline marked on ceiling to position the range
hood as shown in Figure 2.
2. Cut and remove ceiling drywell. Install 2" x 4" cross
framing lumber (not provided) between ceiling joists.
3. Framing should be 11-2/16" (O.C. = on center)
between front and back, and 10-3/16" (O.C.)
between both sides of the 2" x 1" cross framing
lumber. Refer to Figure 3.
4. Finish the ceiling surface.
location of the ceiling joists and cross framing
lumber.
5. Cut a 6-1/2" duct opening and approximately a 1"
wire access hole.
IT MAY CASUE
Be sure to mark the
7
Figure 1
Figure 2
Figure 3