What If There Are Problems; Disposal; Technical Specifications - Beurer LW 230 Mode D'emploi

Item
Beurer by Taoasis "Vitality" aroma oil (10 ml)
Beurer by Taoasis "Harmony" aroma oil (10 ml)
Beurer by Taoasis "Relax" aroma oil (10 ml)
Beurer by Taoasis "Sleep Well" aroma oil (10 ml)
2 x Silver ion pads
Only use original parts and from the manufacturer.

10. What if there are problems?

Problem
No display.
The upper cover cannot be
fitted precisely.
The water level gauge
always shows the same fill
level despite differing water
levels.

11. Disposal

For environmental reasons, do not dispose of the device in the household waste at the end of its useful life.
Dispose of the unit at a suitable local collection or recycling point. Dispose of the device in accord-
ance with EC Directive – WEEE (Waste Electrical and Electronic Equipment). If you have any questions,
please contact the local authorities responsible for waste disposal.
Disposal of silver ion pad according to official regulations (in the appropriate bin).

12. Technical specifications

LW 230
Dimensions (L x W x H)
Cable length
Weight when empty
Power supply unit
Output
Suitable for rooms
Maximum capacity
Silver ion pads
Description
Dimensions
Composition
Active substance
Max. water temperature
CAS number
Item number
681.30
681.31
681.32
681.33
164.160
Cause
The device is not connected to
mains power supply.
The device has switched itself off
due to safety reasons.
The guide rails do not fit and the
upper cover is jammed.
The fill level sensor is dirty.
30 x 30 x 34 cm
approx. 2 m
approx. 5,5 kg
100 – 240 V AC; 50/60 Hz
2-4-7 Watt
up to approx. 40 m²
approx. 7.25 litres
silvertex ® fresh air
5 cm x 5 cm x 1,5 cm (each)
3D fabric made of polyester (PET) and silver-coated polyamide
Silver (Ag) +< 50µg/l
40 °C
7440-22-4
21
Solution
Connect the mains plug and switch on
the device.
Clean and refill the device before next
use. Then switch it on again.
Turn the upper cover around by 180°
and reposition it on the tub.
Remove the upper cover from the tub,
unlock the water level sensor, remove
it and clean carefully.