Connections - Sharp PN-U553 Manuel D'installation

Caution
• Be sure to turn off the main power switch and disconnect the plug from the power outlet before connecting/disconnecting
cables. Also, read the manual of the equipment to be connected.
• Be careful not to confuse the input terminal with the output terminal when connecting cables. Accidentally reversing cables
connected to the input and output terminals may cause malfunctions and the other problems.
1
Power cord
(Supplied)
For power outlet
TIPS
• Set the audio input terminal used for each input mode in AUDIO SELECT on the SETUP menu. The factory settings are
shown below.
Input mode
DVI-D, D-SUB
DisplayPort
HDMI
COMPONENT, VIDEO
• The terms HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks
of HDMI Licensing LLC in the United States and other countries.
• DisplayPort is a registered trademark of Video Electronics Standards Association.
6
E

Connections

2 3 4 5 6
Audio input terminal (Factory setting)
Audio1 input terminal
DisplayPort input terminal
HDMI input terminal
Audio2 input terminals
13
14
7 8 9 10 11
1. AC input terminal
2. RS-232C output terminal
3. RS-232C input terminal
4. LAN terminal
5. HDMI input terminal
6. DisplayPort input terminal
7. DVI-D input terminal
8. DVI-D output terminal
9. D-sub input terminal
10. Audio1 input terminal
11. Component input terminals
12. Video input terminal
13. Audio output terminals
14. Audio2 input terminals
12