Hama PREMIUM X6S Mode D'emploi page 10

g
4.2.2 Shred paper and plastic cards
■ Insert the paper or the plastic card into the centre of the feed shaft
(4). The cutting rollers are switched on automatically.
■ Let go of the paper or plastic card. The device switches off automa-
tically after shredding is completed.
NOTE!
►
4.2.3 Reverse mode
NOTE!
►
■ Slide the operating switch (2) to the "REV" position. The rollers of
the cutting system rotate in reverse.
■ Slide the operating switch (2) to the "Auto" position.
■ Switch approximately three times successively between the posi-
tions "REV" and "Auto".
■ Switch off the device and remove the jammed paper or plastic card
from the feed shaft (4).
4.2.4 Emptying the bin
■ Switch off the device.
■ Lift the cutting shredder head (5) off the waste bin (6).
■ Empty the bin.
■ Put the shredder head (5) back on the waste bin (6).
4.2.5 Switching off the device
■ Slide the operating switch (2) to the "OFF" position.
10
Empty the bin frequently in order to prevent damage to the
device.
These modes serve to remove any blockages in the cutter
system.
Premium X6S