System; General; Firmware/Reset; Log File - Abus IPCA22500 Manuel Utilisateur

10.4.5 System

10.4.5.1 General

Camera name:
Export configuration:
Import configuration:
Reset settings:
Include network:

10.4.5.2 Firmware/Reset

Current firmware:
Firmware online check:
Firmware update:
Restart:
Schedule restart:

10.4.5.3 Log file

Log file: data relevant to the system is recorded in the log file. This can help with
troubleshooting, for example.
Export: exporting the log file into another file

10.4.6 Motion detection

List of ranges:
Display all:
Range name:
Ignore the threshold value:
Delay before alarm:
Add:
you can change the default camera name here. Up to a
maximum of 16 characters are permitted.
Permissible characters are: A-Z, a-z, 0-9
export the camera' s configuration data into a file
import the camera' s configuration data from a file
restore all settings to factory settings, except network
settings
after ticking the checkbox and performing the function for
resetting settings, all settings including the network
parameter are reset.
displays the firmware version currently installed
this function checks whether a new firmware version is
available on the ABUS website. If there is, the camera offers
to download the firmware on to the PC (download link). Then
the firmware must be manually installed using the firmware
update function.
a more recent version of the camera firmware can be
installed here. More information on firmware is available
on the ABUS website (www.abus.com).
manual camera restart
the camera can be restarted here at a specific frequency.
displays all the ranges of movement set
tick the checkbox to display a preview of all ranges at the same
time.
name of range
The threshold value is ignored, thereby causing any small pixel
change movement. This setting can be advantageous with a wide
image width (e.g., outside). However, a delay before alarm should
be used.
Delay time before a motion alarm is triggered after recognition of the
image change.
after assigning the range a name and pressing this button, a new
entry is created in the list. Then click on the list entry to select a
100