En Instructions For Use / Assembly Instructions - Hansgrohe Exafill 58127000 Mode D'emploi / Instructions De Montage

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may not be used as a holding handle. A
separate handle must be installed.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• Connection with flexible hose code nr. 58192000.
(see page 34) Fig. A
Installation to DIN 1988
(see page 34) Fig. B
When installing a different flush-type fitting than the iBox
universal, DIN EN 1717 requires the pipe interruptor
(DB) to be at least 150 mm above the tub brim.
Installation to EN 1717
(see page 34) Fig. C
When assembling the iBox universal with integrated
safety combination (HD) pay attention that the middle of
the mixer is min. 280 mm above the upper edge of the
bath tub.
Use of the flush plug
(see page 34) Fig. D
• Testfilling of the bath tub.
• Flushing of the pipes.
• Pressure test of the pipes between mixer and flush plug
• The residual water jet during pressure test is taken into
account. It shall remind you of closing the mixer after
the pressure test and avoid cross flow at the mixer.
4
English
Technical Data
Sequence power
overflow capacity
Symbol description
Assembly see page 32
Do not use silicone containing acetic acid!
Dimensions (see page 31)
Flow diagram
(see page 31)
Operation (see page 35)
Cleaning (see page 36) and en-
closed brochure
Spare parts (see page 38)
Special accessories (see page 38
order as an extra)
connection hose #58192000
Test certificate (see page 35)
53 l/min
36 l/min