Num'axes PIE1025 Guide D'utilisation page 31

8. SMS commands
You have the option to control the camera remotely via text messages (SMS commands). You
can switch from photo mode to video mode and vice versa, take a picture and receive it, change
the video or photo resolution, etc.
To send a command to the device, you have to insert a code in a text message and send it to
the phone number of the SIM card inserted in the camera.
IMPORTANT
 The MMS or SMTP status must be set to "ON" (800x600, VGA or SMS) in the MMS/SMTP
setup for the SMS function to work. It will not work if the MMS or SMTP status is set to
OFF.
 Some towers do not support all commands.
 You must have a phone number entered in, in order to send commands to the phone. If
you only have an e-mail in the MMS/SMTP setup menu, you cannot use the SMS option.
The phone number in position 1 in the phone number list will be used as the "commander
phone number" and only it has the rights to edit the SMS command orders to control the
camera.
 Both MMS and SMTP allow control of the camera remotely via text messages.
The table below lists the actions or setting changes you can request and the various text
messages which you have to send to your camera:
Requested action or setting change
Switch to camera mode
Switch to video mode
Set photo resolution at 5 MP
Set photo resolution at 8 MP
Set photo resolution at 12 MP
Set video resolution at VGA
# PIE1025 – indice B – Août 2018
Input  Press OK  Email 1 to 4  Press OK to input the e-mail
address of your choice  Press MENU to move back.
SMTP Manual Test – allows you to send an e-mail manually for
testing.
Before starting the test, please make sure the SIM and SD cards are
inserted, the SMTP parameters are set correctly and the Status
parameter is not set to OFF.
You must allow your camera time to search for cellular service. After
the mobile signal shows on the LCD, your can begin the test.
Enter  Press OK to start the test. The camera will take a picture
automatically meanwhile the LCD will show a timer start to count the
transmitting time. Then a message on the LCD display will indicate if
the test is successful or not.
If the test failed check the camera settings and, if necessary, contact
your mobile phone network operator to verify the wireless related
data are correct.
SMS text commands
*CM*
*VM*
*C*1*
*C*2*
*C*3*
*V*1*
31/88