Num'axes PIE1025 Guide D'utilisation page 30

MMS Manual Test – allows you to send an MMS manually for
testing.
Before starting the test, please make sure the SIM and SD cards are
inserted, the MMS parameters are set correctly and the Status
parameter is not set to OFF.
You must allow your camera time to search for cellular service. After
the signal shows on the LCD, your can begin the test.
Enter  Press OK to start the test. The camera will take a picture
automatically meanwhile the LCD will show a timer start to count the
transmitting time. Then a message on the LCD display will indicate if
the test is successful or not.
If the test failed check the camera settings and, if necessary, contact
your mobile phone network operator to verify the wireless related
data are correct.
SMTP settings
SMTP SSL – ON / OFF
If you want the device to send photos or SMS to an e-mail address
via GPRS with SSL protocol.
Note: for the same e-mail account, the mail server port is different
with or without SSL. Please confirm wether the e-mail account you
are using as the "Sender E-mail" is encrypted before setting the
SMTP SSL parameter to ON or OFF.
GPRS parameters – Auto input / Manual input
Auto input - allows you to use pre-programmed parameters. You
will have to select your country and mobile phone network operator.
Press OK  Choose your country using the  and  keys  Press OK
 Choose your mobile phone network operator using the  and 
keys  Press MENU several times to move back
If "Auto input" does not work (which may be due to recent changes
made by your mobile phone network operator) or if your mobile
phone network operator is not in the list for your country, please use
the "Manual input" option (see below). Do not hesitate to check the
settings with your mobile phone network operator.
Manual input – allows you to manually enter the GPRS parameters
(APN, Account, Password).
Note: if you choose to manually input the GPRS parameters, you
need to contact your mobile phone network operator to have them
provide all the required information.
Sender Email – allows you to input the sender's e-mail settings
(SMTP server, Port, Sender email, Send password).
Recipients Email – allows you to input the e-mail addresses that
will receive data from the camera. You can enter up to 4 e-mail
addresses.
# PIE1025 – indice B – Août 2018 30/88