Removing The Bottom Panel; Grease Filter - Novy Pure'line Cubic Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.2 Removing the bottom panel

If the bottom panel is to be removed from the cooker
hood for cleaning, proceed as follows:
− Grasp the bottom panel at the left and right ends.
− Slowly tilt the bottom panel downwards and continue
to hold it in place.
− As soon as the bottom panel is at a 90º angle downwards,
the bottom panel can be slid to the right to remove it
from the hinges. Here you will feel some resistance. Do
this with caution to prevent damage to the cooker hood.
Make sure you hold the bottom panel securely at all times.
− The bottom panel can then be cleaned by hand. The
bottom panel is not suitable for cleaning in the dishwasher.
− Before reinstalling the bottom panel, immediately clean
the accessible parts on the inside of the cooker hood.
− To replace the bottom panel, grasp the bottom panel at
the left and right ends and hold it in place. Make sure
you hold the bottem panel securely at all times.
− Hold the bottom panel in a 90º angle downwards and
slide the bottom panel to the left over the hinges until
you notice a click.
− The bottom panel cannot be closed if the bottom panel
is not fully positioned over the hinges.
− The bottom panel can then be closed.
3.3 Grease fi lter

If the following instructions are not carried out,
serious soiling can cause a fi re hazard.
Indication cleaning grease fi lter
Indication: 4 fl ashing indicator lights
After 20 cooking hours 4 fl ashing indicator LEDs show
that the grease fi lter must be cleaned.
Reset the cleaning indicator
When you replace the grease fi lter after clean-
ing, it is suffi cient to press the
seconds to again set the indicator.
If you do not do this the indicator light will continue to fl ash
when switching on the extractor hood.
Accessing the grease fi lter
Take hold of the right and left side of the bottom panel
(A) and pull down simultaneously. Remove the fi lter (B) by
tak ing hold of its hook and pulling down.
Cleaning the grease fi lter
The metal grease fi lter can be cleaned by hand or in a dish-
washer. We recommend cleaning the grease fi lter by hand.
Cleaning the fi lter by hand:
− Immerse the fi lter in a solution of boiling water to which
− Use a brush for cleaning
− Then rinse the fi lters with warm water under a tap and
Cleaning the fi lter in a dishwasher:
− Use a customary dishwasher detergent
− Do not put the saturated grease fi lters together with
− Select a programme with a low temperature
− After cleaning allow the fi lter to drain.

Replacing the grease fi lters
− Before replacing the grease fi lter, clean the edges of the
− Grasp the fi lter with 2 hands.
− Make sure that the lock or the lip on the fi lter is on the
− Insert the back of the fi lter in the opening, press the fi lter
key for 5
2

– 38 –
a degreasing detergent has been added.
allow them to dry.
crockery in the dishwasher
When cleaning in a dishwasher the fi lter may
discolour as a result of the salt content. This
does not affect its operation.
part in the extractor hood in which the fi lter is placed.
bottom side.
upwards at the front and make sure it clicks tight.
You can obtain a new grease fi lter from a dealer
or the Novy website. Article number grease
fi lter: 6830.020(2x).

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

6838683968486849

Table des Matières