Led Lighting - Novy Pure'line Cubic 6830 Mode D'emploi

Replacing the grease fi lters
− Before replacing the grease fi lter, clean the edges of the
part in the extractor hood in which the fi lter is placed.
− Grasp the fi lter with 2 hands.
− Make sure that the lock or the lip on the fi lter is on the
bottom side.
− Insert the back of the fi lter in the opening, press the fi lter
upwards at the front and make sure it clicks tight.

You can obtain a new grease fi lter from a dealer
or the Novy website. Article number grease
fi lter: 6830.020(2x).
3.3 Monoblock recircuilatiefi lter (optioneel)
When selecting recirculation, always set the recirculation
programme on the extractor hood (see paragraph 2.4)
If recirculation is chosen the appliance is connected to an
outlet box with a monobloc recirculation fi lter, or a monob-
loc recirculation fi lter is fi tted in the extractor hood behind
the grease fi lter.
Replacement indicator monobloc recirculation fi lter

Indication: red indicator light stays on
After a set time a red indicator light on the appliance shows
that the monobloc fi lter must be replaced.
Reset the cleaning indicator

After replacing the monblock fi lter(s), carry out
the following action. The motor of the cooker
hood must be running. Simultaneously press
and for 3 seconds until the red indicator led
3
fl ashes 3 times for confi rmation. If the cooker
hood is not reset, it will automatically reset
after the motor of the cooker hood has been
switched on 10 times.
Installing the monoblock fi lter
Refer to your recirculation kit manual for removal and
installation of the monoblock fi lter.

You can obtain a new monobloc fi lter from
a dealer or the Novy website.

3.4 Led lighting

Replacing the led lighting
First, remove the power supply from the hood and allow
the lighting to cool down suffi ciently.
1. Carefully press the spotlight holder; next, remove the
spotlight holder by means of a tilting movement.
2. Removing the LED lamp:
A. First disconnect the cable to the LED to be replaced.
Disconnect by means of releasing the lock, by applying
light pressure while at the same time pulling away.
B. Next, remove the LED to be replaced by making a gentle
rotating movement to the left.
2
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the LED
light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker hood and
reconnect the power.
– 39 –