Cameo INSTANT FOG 1700 PRO Manuel D'utilisation page 8

SETTING DMX MODE
You can access the options menu by pressing MODE. Using the UP and DOWN control keys, now select the "DMX Mode" menu option and
confirm by selecting ENTER. Use the UP and DOWN keys to select the desired DMX mode (3CH mode / 1CH mode) and then press ENTER to
confirm your selection. The main screen now displays the mode and DMX start address and automatically activates the DMX mode. You can find
detailed DMX tables for both DMX modes in these instructions under "DMX CONTROL".
ENTER
DMX Mode
UP/DOWN
STAND ALONE MODE (Stand Alone)
Stand Alone mode makes it possible to manually configure the fog discharge of the machine using values of 1% to 100%. You can access the
options menu by pressing MODE. Using the UP and DOWN control keys, now select the "Stand Alone" menu option and confirm by pressing
ENTER 2x. Using the UP and DOWN control keys, now set the desired value and confirm via ENTER.
Stand Alone
ENTER
TIMER MODE (Timer)
Timer mode makes it possible to manually configure the fog discharge of the device using values of 1% to 100%, as well asthe output
duration and the interval at which the discharge is to begin. You can access the options menu by pressing MODE. Using the UP and DOWN
control keys, now select the "Timer" menu option and confirm via ENTER. Now select between "Timer Pump" (output quantity), "Timer
Duration" (output duration), and "Timer Interval" (output interval) via UP and DOWN, confirm with ENTER, and set the desired value using UP
and DOWN respectively. Confirm each entry via ENTER.
ENTER
Timer
UP/DOWN
SLAVE MODE (Slave)
You can access the options menu by pressing MODE. Using the UP and DOWN control keys, now select the "Slave" menu option and confirm
via ENTER. Connect the slave and master unit (same model, same software version) using a DMX cable (Master DMX OUT - Slave DMX IN),
and activate Stand Alone or Timer mode on the master unit. The slave unit will now follow the master unit.
Slave
ENTER
DEVICE SETTINGS (Settings)
You can access the options menu by pressing MODE. Using the UP and DOWN control keys, now select the "Settings" menu option (note
arrow) and confirm via ENTER.
Settings
ENTER
This will take you to the submenu for setting the following submenu options (select via UP and DOWN, confirm via ENTER, change status via
UP and DOWN, confirm via ENTER):
8
3CH Mode
/
ENTER
Stand Alone
UP/DOWN
Pump
Timer
/
Pump
ENTER - UP/DOWN ENTER - UP/DOWN
Pump Value
1% - 100%
ENTER
Main display
Slave mode
1CH Mode
ENTER
Pump Value
1% - 100%
Timer
/
Duration
ENTER - UP/DOWN
Duration Time Interval Time
1sec - 60sec 1sec - 60sec
ENTER
Main display
DMX-Mode
DMX-Address: xxx
Main display
Stand Alone mode
ENTER
Pump Value: x%
Main display
Timer mode
Timer
Duration/Interval xSec
Interval
ENTER