HP Photosmart D5400 Série Guide D'utilisation page 9

Masquer les pouces Voir aussi pour Photosmart D5400 Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TIP:
Tap a stack of paper on a flat surface to align the edges. Make sure all the
paper in the stack is the same size and type and free of rips, dust, wrinkles, and
curled or bent edges.
3.
Insert the stack of paper into the main input tray with the short edge forward and the
print side down. Slide the stack of paper forward until it stops.
CAUTION:
Make sure that the product is idle and silent when you load paper
into the main input tray. If the product is servicing the ink cartridges or otherwise
engaged in a task, the paper stop inside the product might not be in place. You
could push the paper too far forward, causing the product to eject blank pages.
TIP:
If you are using letterhead, insert the top of the page first with the print side
down.
4.
Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the main input tray; make sure the stack of paper fits within the main
input tray and is no higher than the top of the paper-width guide.
5.
Lower the output tray. Pull the tray extender towards you, as far as it will go. Flip the
paper catch at the end of the tray extender to open the extender the rest of the way.
Load paper
5

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Q8420a

Table des Matières