Bosch SH 87PW55N Série Notice D'utilisation page 17

Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from §:‹‹ to §:‹‡. The
factory setting is §:‹†.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
Setting Amount
dispenser is OFF
§:‹‹
lowest setting
§:‹‚
low setting
§:‹ƒ
medium setting
§:‹„
medium/high setting
§:‹...
high setting
§:‹†
highest setting
§:‹‡
Open the door.
1.
Press the On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates •:‹x or
š:‹x (x can be any number).
Release both buttons.
4.
The indicator of function key #
flashes and the display 8
indicates the factory set value.
Press the function key # until
5.
the display 8 shows §:‹†.
Press function key 3 to select
6.
the desired setting.
Press Start button P to save
7.
the setting.
Turning off rinse aid
indicator
Proceed as described in the section
"Setting the amount of rinse aid
used" and set value to §:‹‹. The
rinse aid indicator is now turned off.
NOTICE
Using no rinse aid or setting the
dispenser to §:‹‹ may result in
longer cycle times consuming more
energy and water. The higher
temperatures and longer cycle times
can damage fine china or glassware.
Rinse Aid en-us
17