TEMPUR-PEDIC 19005-38.80-3370 Manuel Du Propriétaire page 8

safety precautions and usage statements
FCC Certification Statement
This equipment complies with Part 15 of the FCC Rules. Operation of this
equipment is subject to the following two conditions: (1) the equipment may
not cause harmful interference, and (2) the equipment must accept any
interference that might cause undesired operation.
Radio and Television Interference
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
an can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that such interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by taking one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Important: Any changes or modifications not expressly approved by Tempur
Sealy International ("Tempur") could void the electromagnetic compatibility
compliance and negate your authority to operate this equipment.
This equipment was tested for FCC compliance under conditions that
included the use of Tempur peripheral devices and Tempur cables and
connectors between system components. It is important that you use Tempur
cables and connectors between system components to reduce the possibility
of causing interference to radios, television sets, and other electronic devices.
You can obtain proper Tempur cables and connectors through an Tempur-
authorized dealer.
4
Responsible party (contact for FCC matters only):
Tempur-Pedic North America, Inc.
1000 Tempur Way
Lexington, KY 40511
Sleeptracker Sleep Monitoring System model STS-40 contains FCC ID H8N-
WLL6540.
Industry Canada Statement of Compliance
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device. This device
complies with ICES-003 Class B specifications of Industry Canada.
Responsible party (contact for Industry Canada matters
only):
1390658 Ontario Inc (Tempur Canada)
145 Milner Ave.
Scarborough, Ontario
M1S 3R1
Sleeptracker Sleep Monitoring System model STS-40 contains IC
1353A-WLL6540.
Exposure to Radio Frequency Energy
This equipment complies with radiation exposure limits set forth in the FCC's
OET Bulletin 65 and Industry Canada's RSS-102 standard for an uncontrolled
environment. This equipment should be installed and operated with minimum
distance of 20cm (about 8 inches) between the radiator and your body. This
equipment must not be co-located or operating in conjunction with any other
antenna or transmitter.
Pacemaker Notice
If you use a medical device such as a pacemaker or implantable cardioverter-
defibrillator (ICD), please consult your physician before using this product.