GE AEQ10 Série Manuel D'utilisation Et Instructions D'installation page 10

PRePARe THe WinDoW
4
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
inSTALL THe AiR ConDiTioneR in
5
THe WinDoW
Place the air conditioner on the sill with the
A
bottom mounting rail against its back edge .
Center it and close the window securely behind
the top mounting rail .
It should be level or slightly tilted to the outside .
Use a level; about a 1/3 bubble will be the correct
case slant to the outside .
3 Screws
2 Frame locking brackets
B Extend the left and right accordion panels to
the vertical window sashes and attach 3 screws
through the holes in the upper panels, as
appropriate .
Install the frame locking brackets between the
C
bottom of the accordion panel and the window
sill . Attach with 2 screws . NOTE: To prevent the
window sill from splitting, drive the pilot holes
before driving the screws .
installation instructions
10
inSTALL SuPPoRT BRACKeT AnD
6
foAM ToP WinDoW gASKeT
CAuTion:
A
To prevent broken glass or
damage to windows, on
vinyl or other similarly
constructed windows,
attach the window locking
bracket to the window
side jamb with one screw.
Cut the foam top window gasket to the window
B
width .
Stuff the foam
C
between the glass
and the window
to prevent air and
insects from getting
into the room .
NOTE: If the gasket supplied does not fit your
window, obtain appropriate material locally to
provide a proper installation seal .
Vinyl
Wood