Pioneer FH-X830BHS Mode D'emploi page 15

• Call 1-877-438-9677
4
[SUBSCRIPTION UPDATED] appears on the display when your SiriusXM Connect
Vehicle Tuner has been subscribed successfully.
Press any key to clear the activation message.
NOTE
The activation process usually takes 10 minutes to 15 minutes but may take up to an hour in some
cases. Do not turn off the unit until you clear the activation message in step 4.
Listening to a channel
1
Press and hold DISP, then select [CHANNEL].
You can also select the operation mode by the SiriusXM settings (page 19).
2
Press SRC/OFF to select [SIRIUSXM].
3
Press BAND/ to select a band from [SXM1], [SXM2] or [SXM3].
4
Press / to select a channel.
Pressing and holding either button will rapidly browse through the channels.
Press and hold either button then release to tune automatically. Scanning stops
when the unit receives a channel. To cancel seek tuning, press
Basic operations
1
Press and hold DISP to select the operation mode [CHANNEL] or [REPLAY].
NOTE
You can exit the replay mode by pressing and holding BAND/
Purpose
Select a channel
Skip backward/forward
Fast forward or reverse
NOTE
You can also make various adjustments in the SiriusXM settings (page 19).
/ .
.
Operation
1 Set the operation mode to [CHANNEL].
2 Press
or .
Pressing and holding either button will
rapidly browse through the channels.
1 Set the operation mode to [REPLAY].
2 Press
or .
1 Set the operation mode to [REPLAY].
2 Press and hold
or .
Category scan
The live broadcast for each channel in the current category plays for six seconds at a
time. Follow the instructions below.
To search for a channel from a list
1
Press during playback.
2
Turn the M.C. dial to select a category.
3
Select one of the operations below.
Category scan: Press and hold the M.C. dial to switch to category scan.
Channel search: Press the M.C. dial to stop a scan.
NOTE
Press DISP to change the display information between "Channel Name", "Artist Name", "Song Title",
"Content Info" and "Channel Number".
Scan options
Purpose
Stopping a scan (selecting the channel or
song playing)
Switching to the next/previous song during
TuneScan
Switching to the next/previous channel
during the category scan
Aborting a scan (The last channel or song
will continue to play when scan ends.)
To preset a channel
1
While receiving a channel you want to store, press and hold one of the number
buttons (1/ to 6/ ) until it stops flashing.
To play the stored channels, select the band and then press a number button (1/
6/ ).
To preset a channel from a list
1
While receiving a channel you want to store, press
2
Turn the M.C. dial to select [PRESETS], then press to confirm.
3
Turn the M.C. dial to select a preset channel.
4
Press and hold the M.C. dial to store.
Operation
Press the M.C. dial.
Press or .
Press or .
Press BAND/ .
.
to
15
En