Installing The Ceiling Assembly (9400 Series) - Airxcel 47000 Série Instructions D'installation

IX. INSTALLING THE CEILING ASSEMBLY (9400 SERIES)
Make sure that you have properly matched the roof top air
conditioner and interior ceiling assembly. The following step-by
step instructions must be performed in the following sequence to
insure proper installation.
A. Remove ceiling assembly from carton, separate
individual items and remove the two grilles and
filters from the ceiling shroud.
B. Fold and break off the 3 tabs around the inner
opening of the duct collar then fasten the duct collar
to the air conditioner basepan with 3 provided screws
(See Figure 12).
FIGURE 9
C. Raise the ceiling assembly chute and insert the
supply wiring through the cable clamp and into
the wiring box so that 4-6" of supply conductor
is inside the box. Secure the cable clamp over
the supply wire sheath so that no movement is
possible (See Figure 10).
D. Connect the supply power black conductor to the
black pigtail wire, the white conductor to the white
pigtail wire and the supply ground conductor to the
green pigtail wire found in the wiring box using the
3 provided wire nuts. Using a U.L. approved
electrical tape, secure the wire nuts in a
workmanlike manner (See Figure 11).
10