Maintenance And Storage - WRC Kwadoo 2R Manuel D'utilisation

5 CLEANING
How to take out the robot from the pool :
Pull with precaution as far as the rank pool
Catch the robot thanks to its handle
Lift it slowly taking it also by its inferior handle
which will help to evacuate the water held inside
Important to do after each use :
Stand the robot on the back on a flat surface.
Push both filter box clips simultaneously to take it out
from the robot.
Remove and clean the filter with a water jet.
Empty and rinse the tank.
Let the filter get dried outside from the robot
if you store it.
To refit the filter :
Insert the hooping of the filter in the box
Share out the cloth bag in the box bottom.
Put back the bow in the robot with the water
Entrees towards down.
Make sur that the box is sticked on the robot then
release the box clips.
6

MAINTENANCE AND STORAGE

One time per week or depending on the use :
Unplug and unwind the complete cable.
Rinse the inside and outside part of the robot with clear water, excluded all kind of solvent.
Nota : no parts need to get greasy
Store the device and the control box sheltered from sun
7 TROUBLESHOOTING
The control box is turned on but the robot doesn't move or very slowly :
(A) Clean the filter.
Nota : The robot is propulsed by water jet coming from inside the robot if the filter
is saturated by green algaes or by waste, the robot wouldn't move anymore.
(B) Check that the filter box is set well.
(C) Check that the robot is not abnormally dirty or full of sand in the internal of flow dis-
tribution part ( in case of a damaged filter or wound up in a bad way.
In that case clean inside the robot with a water jet.
The control box doesn't turn on anymore or the robot doesn't move :
please go to our after sale service on the website
www.kwadoo.com.