WRC Kwadoo 2R Manuel D'utilisation page 7

3 USE
After Unpacking and before the first use of your robot, unwind and untwist for all the length,
the electric cable floating
The device needs to work without any knots.
Don't use the cable to lift the robot out of the water or the damage that you might cause to
the electric links will be irreversible.
Place the control box to a half-length of the pool and no less than 3.5m from the pool edge.
Make sure that the box is connected to a mains socket outlet with a protective earthing
connection.
Connect the cable to the control box
Put the robot on the water surface and let it putting down to the bottom
Make sure you have enough cable length on the surface of the pool.
The robot is ready to start its cleaning cycle.
Check the filter box is well set.
Set the control box under cover from the sun
to optimize the lifetime of your device.
4 MACHING RUNNING
Push the button M/A to start the cleaning cycle
A green light will flash during 8 s then the robot will start
While the light is flashing, you can select the program adapted to
the length of your pool pressing the M/A button.
A program is available for pools as far as 6 m ; 8m ; 10m ; 12m ; 15m.
The selected program will be registered for the next start.
The « F » program is a filtration aid for the pool, a cycle of 6 hours while
the robot will move each 15 min.
To turn off the robot before the cycle cleaning end, press M/A
A red light will switch on for 8s then the device will shut down.