AEG A75100GA4 Notice D'utilisation page 29

3. Unscrew both adjustable feet.
4. Unscrew the screws of the door bottom
hinge.
5. Take off the appliance door by pulling it
slightly downwards.
6. Unscrew the top door hinge pin of the
appliance then screw it back on the oth-
er side.
7. Fit the appliance door on the upper door
hinge pin.
8. Remove the lower hinge. Put over the
pin in the direction of the arrow.
9. Unscrew and install the screw on the
opposite side.
10. Install the lower hinge on the opposite
side leaving the position of the door un-
changed.
11. Screw in the one screw in the place set
free on the other side as well as the adjustable feet (2 pieces).
12. Remove and install the handle
opposite side.
13. Reposition, level the appliance, wait for
at least four hours and then connect it
to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket.
In case you do not want to carry out the above mentioned operations, contact the nearest
After Sales Service Force. The After Sales Service specialist will carry out the reversibility of
the doors at your cost.
10) If foreseen
10)
on the
29
Installation