Safety Instructions For Installation And Maintenance Work; Unauthorised Conversion And Production Of Spare Parts - WITA go.future LED 40 Série Instructions De Montage

• Observe the instructions in local or general
regulations (e.g. IEC, VDE, etc.), and those of the
local energy supplier.
• In the event of hazards arising from the system due to
Display HE Pumpen
contact with hot or cold parts, these parts must be fitted
with a touch guard.
• Keep flammable substances away from the product.

2.7 Safety instructions for installation and maintenance work

The system operator is responsible for ensuring that all
installation and maintenance work is carried out by qualified
personnel. These persons must also have familiarised
themselves in advance with the product using the operating
instructions. Conducting work on the pump is only permitted
when the system is shut down.
Ensure that the device is securely disconnected from the power
supply. Disconnect the device plug to achieve this.
Prescribed instructions for shutting down the device can be
found in the operating instructions. All protective mechanisms,
such as a touch guard, must be correctly reattached after work.

2.8 Unauthorised conversion and production of spare parts

Modification or conversion of the product is only permitted after
prior consultation with the manufacturer. Only use original spare
parts for repairs. Only use accessories that have been approved
by the manufacturer. The manufacturer shall bear no liability for
any consequences resulting from the use of other parts.
WITA go.future LED 40-XX | 60-XX
Operating Instrutions
25