Daikin FTXK09P Manuel D'installation page 7

• Remote controller (wireless kit) transmitting distance
can be shorter than expected in rooms with electronic
fl uorescent lamps (inverter or rapid start types). Install
the indoor unit far away from fl uorescent lamps as
much as possible.
• Indoor units are for indoor installation only. Outdoor
units can be installed either outdoors or indoors. This
unit is for indoor use.
• Do not install the air conditioner or heat pump in the
following locations:
( a) Where a mineral oil mist or oil spray or vapor isproduced,
for example, in a kitchen. Plastic parts maydeteriorate
and fall off or result in water leakage.
( b) Where corrosive gas, such as sulfurous acid gas,
isproduced. Corroding copper pipes or soldered partsmay
result in refrigerant leakage.
( c) Near machinery emitting electromagnetic waves.
Electromagnetic waves may disturb the operation ofthe
control system and cause the unit to malfunction.
( d) Where fl ammable gas may leak, where there is
carbonfi ber, or ignitable dust suspension in the air, or
wherevolatile fl ammables such as thinner or gasoline
arehandled. Operating the unit in such conditions can
cause a fi re.
• Take adequate measures to prevent the outdoor unit
from being used as a shelter by small animals. Small
animals making contact with electrical parts can cause
malfunctions, smoke, or fi re. Instruct the user to keep
the area around the unit clean.
NOTE
• Install the power supply and inter-unit wires for the
indoor and outdoor units at least 3.5ft away from
televisions or radios to prevent image interference or
noise. Depending on the radio waves, a distance of 3.5ft
may not be suffi cient to eliminate the noise.
• Dismantling the unit, treatment of the refrigerant, oil
and additional parts must be done in accordance with
the relevant local, state, and national regulations.
• Do not use the following tools that are used with
conventional refrigerants: gauge manifold, charge hose,
gas leak detector, reverse fl ow check valve, refrigerant
charge base, vacuum gauge, or refrigerant recovery
equipment.
• If the conventional refrigerant and refrigerator oil are
mixed in R410A, the refrigerant may deteriorate.
• This air conditioner or heat pump is an appliance that
should not be accessible to the general public.
• As design pressure is 536 psi, the wall thickness fi eld-
installed pipes should be selected in accordance with
the relevant local, state, and national regulations.
Disposal requirements
Your air conditioning product is marked with this symbol. This means that electrical and electronic products shall
not be mixed with unsorted household waste.
Do not try to dismantle the system yourself: the dismantling of the air conditioning system, treatment of the
refrigerant, of oil and of other parts must be done by a qualif ed installer in accordance with relevant local
and national legislation.Air conditioners must be treated at a specialized treatment facility for re-use, recycling
and recovery. By ensuring this product is disposed of correctly, you will help to prevent potential negative
consequences for the environment and human health. Please contact the installer or local authority for more
information.
Batteries must be removed from the remote controller and disposed of separately in accordance with relevant
local and national legislation.
• Refrigerant gas is heavier than air and replaces oxygen.
A massive leak can lead to oxygen depletion, especially
in basements, and an asphyxiation hazard could occur
leading to serious injury or death.
• Do not ground units to water pipes, gas pipes, telephone
wires, or lightning rods as incomplete grounding can
cause a severe shock hazard resulting in severe injury or
death. Additionally, grounding to gas pipes could cause
a gas leak and potential explosion causing severe injury
or death.
• If refrigerant gas leaks during installation, ventilate the
area immediately. Refrigerant gas may produce toxic
gas if it comes into contact with fi re. Exposure to this
gas could cause severe injury or death.
• After completing the installation work, check that the
refrigerant gas does not leak throughout the system.
• Do not install unit in an area where fl ammable materials
are present due to risk of explosions that can cause
serious injury or death.
• Safely dispose all packing and transportation materials
in accordance
ordinances. Packing materials such as nails and other
metal or wood parts, including plastic packing materials
used for transportation may cause injuries or death by
suffocation.
NOTICE
1-5
DANGER
with federal/state/local laws or