Installation Of The Outdoor Unit; Installation Clearances - Daikin FTXK09P Manuel D'installation

Drain work. (Heat Pump Unit Only)
1. Use drain elbow for drainage.
2. If the drain port is covered by a mounting base or fl oorsurface,
place additional foot bases of at least 1-3/16"(30mm) in height
under the outdoor unit's feet.
3. In cold areas, do not use a drain elbow, drain plugs and adrain
hose with the outdoor unit. (Otherwise, drain watermay freeze,
impairing heating performance.)
The outdoor unit must be installed in such a way, so as to
prevent short circuit of the hot discharged air or obstruction to
the smooth air fl ow. Please follow the installation clearances
shown in the fi gure. Select the coolest possible place where
intake air temperature is not greater than the outside air
temperature (Refer to operating range).

Installation clearances

Dimension A
Minimum Distance, 11-13/16
Inch (mm) (300)
Note: If there is any obstacle higher than half, of the unit's
height (H), please allow more space than the fi gure indicated
in the above table.
Condensed Water Disposal Of Outdoor Unit (Heat
Pump Unit Only)
• There are 2 holes on the base of Outdoor Unit for condensed
water to fl ow out. Insert the drain elbow to one of the holes.
• To install the drain elbow, fi rst insert one portion of the
hook to the base (portion A), then pull the drain elbow in
the direction shown by the arrow while inserting the other
portion to the base. After installation, check to ensure that
the drain elbow clings to base fi rmly.
• If the unit is installed in a snowy and chilly area, condensed
water may freeze in the base. In such case, please remove
plug at the bottom of unit to smooth the drainage.
A
BASE
DRAIN ELBOW
DRAIN ELBOW

INSTALLATION OF THE OUTDOOR UNIT (18/24)

B C D
39-3/8 11-13/16 19-11/16
(1000) (300) (500)
A
C
09/12
18/24
1-8
Drain water hole
Bottom frame
Drain Elbow
Hose (available commercially,
inner dia. 5/8" (16mm))
B
H/2
D
Please remove
side plate when
connecting
the piping and
connecting cord
PUSH & PULL UP
Please remove
side plate when
connecting
the piping and
connecting cord
PUSH & PULL UP