How The Dustbag Change Indicator Works; How To Replace The Dustbag; When To Change The Motor Protection Filter; How To Change The Motor Protection Filter - Miele Compact C2 SD 3 Série Mode D'emploi

To check the dustbag change indic-
ator
 Attach the standard adjustable floor-
head to the vacuum cleaner.
 Switch the vacuum cleaner on and
select the highest power setting.
 Lift the floorhead off the floor a little.
How the dustbag change indicator
works
The dustbag change indicator is set for
normal household dust. This generally
contains a mixture of dust, hair,
threads, carpet fluff, grit etc.
However, if the cleaner has been used
to vacuum up fine dust, such as plaster,
brick dust, cement or flour, the pores of
the dustbag will become blocked very
quickly.
This affects the air permeability of the
bag, and the marker will indicate that
the bag is "full" even when it is not. If
this happens you must still change the
dustbag because suction power will be
greatly reduced by blocked pores in the
dustbag.
If, on the other hand, a large amount of
hair and carpet fluff which typically con-
tains a lot of air is vacuumed up, the in-
dicator may fail to react even though
the bag is full. For this reason, you
should check the dustbag regularly and
change it if necessary. Both these ex-
tremes can occur.

How to replace the dustbag

(dia. 29 + 30)
 Press the release catches at the side
of the hose connector, and lift the
hose from the socket (dia. 02).
 Press the release catch for the dust
compartment lid and raise the lid as
far as it will go (dia. 11).
The dustbag has a flap which closes
automatically when the dust compart-
ment lid is raised to prevent any dust
escaping.
 Pull the dustbag out by the grip on
the collar.
 Fit the new dustbag into the red
holder as far as it will go. Leave it fol-
ded up when you take it out of the
box.
 Close the dust compartment lid se-
curely, making sure it clicks into posi-
tion. Take care not to trap the dust-
bag when doing so.
A safety device prevents the lid clos-
ing without a dustbag in place. Do
not use force!
 Insert the hose connector into the
suction socket on the vacuum
cleaner until it clicks into position. To
do this, line up the guides on the two
pieces (dia. 01).
When to change the motor protection
filter
Replace this filter every time you start a
new packet of dustbags.
Every packet of original Miele dustbags
contains a motor protection filter. Mul-
tipacks contain four motor protection
filters.
How to change the motor protection
filter (dia. 31)
 Open the dust compartment lid.
en
43