Definitions And Pictograms; Definitions; Pictograms; Description And Markings - Tractel dynafor Expert 0.5 Manuel D'installation, D'emploi Et D'entretien

14. When the product is finally withdrawn from service,
it must be scrapped in such a way that it cannot be
used again. Comply with environmental protection
regulations.
GB
15. This product is approved according to European
regulations and the standards specified in the
section "11. Regulatons and standards", and must
be verified for compliance with the regulations of
any other country in which it may be used, prior
to commissioning and use. Comply with such
regulations.
16. Any use of this product with additional equipment
that relays its signals to an operating system
must be preceded by a risk analysis specific to
the operating functions used and all appropriate
measures must be taken accordingly.

2. Definitions and pictograms

2.1. Definitions

In this manual, the following terms have the meaning
given below:
"Product": Item or equipment described in this manual
and delivered complete in the standard version, or in its
various existing models.
"Installation": All the operations required to bring
the complete product from the state in which it was
delivered into a state of commissioning (or connection
to other elements for commissioning).
"Supervisor": Individual or party responsible for the
management and safe use of the product described in
the manual.
"Technician": Qualified person familiar with the
product, in charge of the maintenance operations
described and permitted in the manual.
"Operator": Individual using the product in accordance
with the instructions in this manual.
"MR": Measurement Range (full scale).
"SWL": Safe Working Load.

2.2. Pictograms

"DANGER": When placed at the beginning of
a paragraph, it indicates instructions for preventing
injuries ranging from minor to fatal and also
environmental damage.
"IMPORTANT": When placed at the beginning
of a paragraph, it indicates instructions for preventing
6
product failure or damage which would not directly
endanger the life or health of operators or other
individuals and/or which may harm the environment.
NB: When placed at the beginning of a
paragraph, it indicates the necessary precautions to
apply for efficient and ergonomic installation, use and
maintenance.
: When placed on the product itself or a product
component, it indicates the need to read the operating
and maintenance manual.

3. Description and markings

3.1. Presentation

Dynafor™ Expert are precision force sensors (0.1%
MR) for measuring forces and indicating loads. The
capacity range is from 0.5 t to 10 t.
The material is delivered with its batteries in a case*
containing:
• The dynafor™ Expert.
• Its installation, operating and maintenance manual.
• Its adjustment certificate.
• Its CE declaration of conformity.
Adjustment certificate
This document is valid for one year and certifies that
the sensor has been adjusted using an internal Tractel
procedure on a calibration bench with a standard
sensor connected to the international standard.
Option: Calibration certificate ISO 376
On request, the sensor can be delivered with an ISO
376 calibration certificate.
This document, which is valid for up to 26 months,
certifies that the product has been calibrated in
accordance with ISO 376, on a calibration bench whose
standard sensor is connected to the international
standard.
The special patented shape of the fastening heads
allows conventional shackles or standardised chain
accessories to be used.
The technologies implemented at the levels of radio
and software offer, in addition to the traditional uses
expected of a dynamometer, multiple configuration
possibilities that combine several sensors. They
also provide access to advanced functions such as
recording, threshold management and monitoring.
The option of a PC link via a USB port opens the door
to data management and archiving.
®