Regulations And Standards; Troubleshooting; Declaration Of Conformity - Tractel dynafor Expert 0.5 Manuel D'installation, D'emploi Et D'entretien

11. Regulations and standards

The product described in this manual complies with the
following:
European standards
Machinery Directive 2006/42/EC
RED Directive: 2014/53/UE
Reference of radio standards
EN300440 V2.1.1
EN300328 V2.2.2
ETSI 203367 V1.1.0
Reference of health standards
EN62479 (2010)
Reference of EMC standards
EN61326-1 (2013)
EN301 489- 1 & 17
Reference of electrical safety standards
IEC/EN61010-1 (Amd 1 ed. 3)
International standards
IEC 61326-1 ed. 2: 2012
IEC 61311: 2007
American and Canadian standards
Reference of radio standards
FCC section 15
RSS-GEN & RSS-210
Reference of EMC standards
FCC section 15
ICES-003
Problems
The sensor does not turn on
Sensor LED flashing at 4 Hz
(4 times a second)
For any other issues related to the remote display unit, see the manual.
Copy of the declaration of conformity in the appendix
NB: This equipment has been tested and deemed
to comply with the limits for a class A digital device,
pursuant to section 15 of the FCC regulations. These
limits are designed to provide reasonable protection
against harmful interference when the equipment is
used in a commercial environment. This equipment
generates, uses and can emit radio waves, and if not
installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operating this equipment in a
residential area is likely to cause harmful interference,
in which case the user must eliminate the interference
at his or her own expense.
NB: This product complies with Industry Canada's
RSS applicable to licence-exempt radio apparatus.
The equipment may be operated under the following
two conditions: (1) it must not cause any interference,
and (2) the user of the device must be prepared to
accept any radio interference received, even if such
interference is likely to affect the operation of the device.
In accordance with Industry Canada regulations, this
radio transmitter may be operated with an antenna of
a type and maximum gain (or less) approved for the
transmitter by Industry Canada.
To reduce the risk of radio interference for other users,
the type of antenna and its gain should be chosen so
that the equivalent isotropic radiated power (e.i.r.p.)
does not exceed the intensity required to establish
satisfactory communication.

12. Troubleshooting

Possible causes
Batteries empty.
Defective electronics.
No communication between the
sensor and its printed circuit
board.

13. Declaration of conformity

Remedies
Replace the batteries.
Contact Tractel
®
Contact Tractel
®
11
GB