Installation Procedure - Toto Vivian TS220E Manuel D'installation Et D'utilisation

N OTE: Thoroughly flush the water supply line prior to installation.
IMPORTANT!
For proper installation, a nipple with a 1/2" NPT male thread extending
between 3/8" (10mm) and 3/4"(19mm) beyond the finished wall is required.
NOTE: The hole for the nipple should not be larger than 1" (25mm) in
diameter.
1. Wrap pipe tape around the free end of the nipple, then thread the pipe
adapter onto the nipple, taking care not to damage the o-ring.
2. Apply silicone caulk around the nipple where it exits the wall.
3. Slide the spout onto the pipe adapter, taking care not to damage
the o-ring.
4. Secure the spout with the set screw.
Pipe Adapter
Tub Spout

INSTALLATION PROCEDURE

Finished
Wall Surface
Min: 3/8" [10mm]
Max: 3/4" [19mm]
1/2" NPT Nipple
Wrap with Pipe Tape
4
Mixing Valve
Apply
Silicone Caulk
Set Screw
Hex Key
From