Listening With Headphones - Teac CD-P1260MKII Mode D'emploi

Listening with headphones

To listen with headphones, turn the LEVEL knob to minimize the
volume level before connecting the headphones plug to the
PHONES jack. Then, adjust the volume after connecting the plug.
Connected speakers will make no sound when headphones are
plugged in.
Caution:
Do not connect headphones with the PHONES jack while
wearing them. Moreover, do not disconnect headphones or
turn the unit on or off while wearing them. Very loud sound
could be output from the headphones.
AVOID DAMAGING YOUR HEARING - Do not put on
headphones until after plugging them in.
12
Basic operation (continued)
Changing the playback time display
During CD playback, press the remote control TIME button to change
the display.
Song elapsed
Displaying MP3/WMA information
During MP3/WMA playback, press the DISPLAY button to show
information about the playing file on the display. Press again to cycle
through the information shown in the following order.
Press the DISPLAY button for more than 1 second again to cancel the
MP3/WMA information mode.
< "
< "
< The display of this unit can only show single-byte letters and num-
Skipping to the next folder (MP3/WMA)
Press the MP3 FOLDER buttons (j/k) to skip folders.
Use the remote control FILE buttons (j/k) to skip files.
Song
remaining
e
time
time
File name e Song e Albume Artist
" appears when there is no information.
" appears when the unit cannot read the information.
bers. If a file name uses Japanese, Chinese or other double-byte
characters, playback is possible but the name will not be shown
correctly. In such cases, "
Disc
Disc elapsed
remaining
e e
time
time
" is displayed.