Combining Multiple Drivers - AUDIOropa ProLoop D5 Mode D'emploi

4.7 Combining multiple drivers

4.7.1 Master over Slave
Master unit
»90°« Output
To establish a low overspill or high coverage system:
- Connect the respective inductive loops to the »speakON« connectors on the drivers.
- Connect an audio source to INPUT 1, 2 or 3 of the Master driver unit.
- Connect the »90°« output jack socket of the Master unit to the »IN« jack socket of the
Slave unit using a 6.35mm to 6.35mm jack cord.
- Power all components up and adjust accordingly.
4.7.1 Slave to Slave
Unit 1
»0°« Output
To establish a high coverage system:
- Connect the »0°« jack socket of the loop driver number 1 to the IN jack of the next loop
driver.
- Power all components up and adjust accordingly.
This allows you to utilise several drivers on the same input. This can be of use if several
rooms are on the same audio transmission.
connected to
connected to
Slave unit
»IN« Input
Unit 2
»IN« Input
English 31