Team Orion Advantage ONE Duo Mode D'emploi page 7

To enter the advanced settings menu, press the SET/
MODE key from the main screen and then use the ENTER
and +/- keys to select and modify the settings.
 Power allocation
This setting allows to change the power output balance
between the two charge channels. For example if you need
to charge a higher voltage battery like a 4S LiPo battery,
allocating more power to the channel charging the battery
will allow for a faster charge.
Press the SET key, the channel number flashes at the
same time as the power value, adjust the value moving the
cursor with the +/- keys, confirm by pressing the ENTER
key again.
 Key Beep
Allows the user to switch the beep tone on/off.
 Safety Timer
The charger is equipped with a safety timer which inter-
rupts the charge when the set time is reached. The default
setting is 120 minutes and the setting range is 10 minutes
to 600 minutes.
 Voltage display
This screen displays the actual input/output voltage for
the selected channel. Input voltage is the power supply
voltage (external or internal), output voltage is the actual
voltage of the battery connected to the selected channel.
www.teamorion.com
 Cell voltage display
This screen displays the cell voltage of the individual cells
of the battery connected to the selected channel. This
applies to LiPo/LiFe batteries equipped with a balancing
connector connected to the balance port of the charger.
WARRANTY
Team Orion guarantees this product to be free from
manufacturing and workmanship defects. The warranty
does not cover incorrect installation, components worn by
use, or any other problem resulting from incorrect use or
handling of the product. No liability will be accepted for any
damage resulting from the use of this product. By the act
of connecting and operating this product, the user accepts
all resulting liability.
Is considered incorrect use:
 Failure to follow instructions.
 Improper use of the product (abusive use, out of spec,
etc.).
 Failure to adapt settings for proper function (improper
connections, wrong gearing, installation, setup, etc.).
 Overload, overheating (desoldering, melting, etc.).
 Running in inadequate conditions (damage or rust from
rain, humidity, etc.).
 Improper maintenance (presence of dirt, etc.).
 Disassembly, modification by the user (modifying
original connectors, wires, components, etc.).
 Mechanical damage due to external causes.
English - 7