Télécharger Imprimer la page

EXIT Toys Aksent Boat Sandpit Mode D'emploi page 15

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
3. Warnings for safe use, maintenance and assembly:
Please read carefully and keep all enclosed information for future reference.
1. ASSEMBLY AND SAFETY INFORMATION
The product must be assembled by an adult. They must be erected exactly in accordance with the assembly
instructions. Enlisting the aid of a helper will make assembly easier. In order to ensure the correct tensions and to
ease assembly, it is important to assemble the product hand tight to begin with. Only when complete, should the
fastenings be fully tightened and checked. Please take care during assembly as the manufacturing
process can sometimes result in the occasional sharp edge and small pieces of waste metalwork. General instruc-
tion to kit/accessory about installation of rope/nets (in relation with the diameter fixed at both ends, length of
pending, interaction with other structure. Should there be any missing parts, the toy must not be used until
replacement parts have been fitted.
2. SITING
Under no circumstances should any of our toys be positioned on a hard surface such as concrete or asphalt, un-
less the ground under the toy plus the recommended freespace area is covered with a safety surface. Examples
of suitable surfaces are grass, sand or a play surface intended for this use. The product should be sited on level
ground.
3. USAGE
The products are designed and made for family outdoor domestic use only by children aged 24 months+, unless
otherwise stated, and must not be used by anybody else. Misuse can result in injury.
4. SUPERVISION
Children should always be supervised while they are playing on the product and should be instructed not to use
the toy in an inappropriate or hazardous manner. We recommend that they do not wear loose-fitting clothing or
jewellery that may catch or snag during play. Children should not wear cycle helmets while playing on the product.
5. WEATHER CONDITIONS
Special care should be taken as weather conditions change. In particular, outdoor toys can become slippery in wet
weather and tongues and lips can stick to metalwork at subzero temperatures. In warmer and sunnier weather,
parts can become hot, and the temperature should be regularly checked during play, especially metal parts and
slides. If there is any doubt over safety then the toys should not be used. If high wind is expected or forecasted,
please ensure that the outdoor toys are either moved to a sheltered position or well secured to the ground or
other immoveable object. Please store plastic swing accessories indoors if temperature falls below
40°F (4°C).
6. WATER PLAY
Many surfaces can become slippery during water play. Extra caution and supervision is required when combining
water (e.g. paddling pools, aqua slides etc.) with other forms of outdoor play.
7. MAINTENANCE
With all toys it is vital that the equipment is checked regularly and often by an adult. The complete toy should be
checked at least once a month, and particular attention should be paid to connections and fastenings. If any parts
exhibit signs of wear and tear, they may need to be replaced. Checks must be carried out at the beginning of the
usage season as well as at regular intervals throughout the usage season. Check all nuts and bolts for tightness
and tighten when required. Failure to do this may result in the product malfunctioning and causing injury. Children
must not be allowed to use the toy until properly installed and checked. Changes to the original toy (for example
the adding of an accessory) shall be carried out according to the instructions of the retailer of the original toy.
8. FIRE RISKS AND DISPOSAL
Never allow the product to be placed or used near a fire. When it becomes necessary to dispose of your equip-
ment, remove all bolts and disassemble. Store out of the reach of children until it can be properly disposed of.
These instructions are issued in the interest of child safety, and we do ask you to follow our advice.
9. SWINGING TOYS
When fitting swinging toys it is vital that moving parts have no metal to metal contact. Children should be in-
structed not to pass in front of or behind moving items, not to twist or swing an empty swing seat, and not to get
off a swinging toy when it is in motion.
10. ROPES
These ropes will degrade over time. When signs of degradation appear, the toy should be replaced.
15
MWO-52107-V02

Publicité

loading