Location Of Controls; Lcd Display; Mounting Instructions - Roadstar CLR-725BT Manuel D'instructions

1 English

LOCATION OF CONTROLS

1. Spacers for sub - assembly
2. Screw for sub - assembly

3. LCD Display

4. MIC (Microphone)
5. BT indicator light
6. ANSWER/PROG./AMS button (accept call/presetting of
7. SKIP+ button
8. SKIP- button
9. VOL+/VOL- buttons (volume)
10. POWER/FUNCTION (on/off/standby/function mode))
11. SLEEP button (sleep timer)
12. PRE.+/ALARM 2 button
13. PRE.-/ALARM 1 button
14. TIME SET/COOK TIMER button (time setting/timer)
15. 15 SNOOZE/DIMMER button (Snooze/display illumination)
16. BATTERY BACKUP
17. AC POWER CORD
18. FM ANTENNA

MOUNTING INSTRUCTIONS

For the installation the cupboard must fulfil the following conditions:
•
Thickness of the cupboard floor between 16 mm and 20 mm.
•
The wall mounting of the cupboard must be stable and anchored firmly in
the wall with at least 2 screws.
•
Important! Do not install the device above a cooker!
•
When installing the device it must be ensured that there is a power soc-
ket within reach.
•
The mains socket must be within easy reach, so that the plug can be
quickly removed in an emergency.
•
Important! Do not connect the device to the mains power supply until af-
ter installation!
•
The device cannot be installed under cupboards under which there is a
lighting strip.
•
For mounting, you may need the following supplies: A drill with 6 mm drill
bit, pilot drill or nail, Allen key, tape measure, adhesive tape, scissors, sa-
fety goggles.