JB Systems CONTROL 5.2 Mode D'emploi page 5

ENGLISH
REAR PANEL
24. DJ MICRO input: Used to connect a balanced (stereo jack) or unbalanced (mono
jack) micro to this channel.
25. LINE input: Used to connect any line level sound source to this channel.
26. PHONO input: Used to connect a turntable to this channel.
27. PHONO/LINE switch: Used to select either the phono input(26) or microphone
input(24) on channels 4 and 5.
28. RECORD BUS A: line level output with the signals from channels 2 to 5. Only the
channels where you selected zone A will be on this output.
Important note: the tone controls, DJ microphone and talkover function are NOT available on this
output. This means that the DJ can talk as much as he wants; on this output only the music will be
recorded.
29. MASTER A unbalanced output: Used to connect an amplifier with unbalanced
inputs. The output level can be set by the MASTER A level (18).
30. MASTER A balanced output: Used to connect an amplifier with balanced inputs.
The output level can be set by the MASTER A level (18).
31. RECORD BUS B: line level output with the signals from channels 2 to 5. Only the
channels where you selected zone B will be on this output.
Important note: the tone controls, DJ microphone and talkover function are NOT available on this
output. This means that the DJ can talk as much as he wants; on this output only the music will be
recorded.
32. MASTER B unbalanced output: Used to connect an amplifier with unbalanced
inputs. The output level can be set by the MASTER B level (16).
33. MASTER B balanced output: Used to connect an amplifier with balanced inputs.
The output level can be set by the MASTER B level (16).
34. MAINS INPUT: connect the supplied mains cable to a 230V/50Hz mains outlet.
Before use, inspect the cable to be sure it's not damaged!
35. MAIN FUSE: The main fuse protects the mixer. Replace it only with the same
type and value.
JB SYSTEMS®
OPERATION MANUAL
5/36 CONTROL5.2 / MIX5.2 MIXER
ENGLISH
SPECIFICATIONS
Power Supply: AC 230 V, 50Hz
Fuse: 20mm glass fuse 250V 500mA slow
Frequency response: 20-20.000Hz (+/-2dB)
THD + noise: <0.1% @ 1kHz, 0dB
S/N Ratio (IHF-A): >85dB @ 1kHz.
Micro inputs: 1.5mV @ 10kΩ
Line/CD inputs: 150mV @ 22kΩ
Phono inputs: 3mV @ 47kΩ
Record output: 775mV @ 600Ω
Master A/B output: 1.5V @ 4k7Ω unbal.
Master A/B output: 850mV @ 600Ω bal.
Talkover: 0dB  -15dB
Tone controls: +/-12dB @ 10kHz / 1kHz / 100Hz
Headphone: 1V@33Ω
Dimensions: 483(W) x 134(H) x 130(D) mm
Weight: 2kg
JB SYSTEMS®
OPERATION MANUAL
6/36 CONTROL5.2 / MIX5.2 MIXER