Bartscher Deli Plus Mode D'emploi page 23

•
Insert the shelves into their guides.
•
Place the water tray in its proper location.
The water tray is designed to create humidity inside the cabinet, to prevent food from
drying out too quickly (this is especially important for baked goods).
•
Fill the tray with water.
NOTE!
Do not pour so much water that it spills.
Observe the level of water in the tray, and add more as needed.
•
First, insert the power cord into the inlet, then into a wall socket.
•
The device is equipped with LED lighting. It may be turned on using the switch
located at the rear of the device.
•
Turn the device on using the ON/OFF switch at the rear of the device.
Heating food
•
Set the required temperature (30° C - 90° C) using th e temperature dial at the rear of
the device.
•
The orange heating control light next to the temperature dial will come on. When the
desired temperature has been reached, the heating device will go off and the orange
light will go out. If the temperature in the device begins to fall, the heater will come
back on and the light will come on as well.
•
The temperature inside the cabinet can be checked by reading the temperature
indicator at the front of the device.
•
Place food in appropriate containers on the trays in the cabinet.
•
After filling the device, close the front doors to avoid loss of heat from the cabinet.
WARNING! Hot surface!
When in use, parts of the device get very hot. To avoid burns, do not touch hot
parts of the device with bare hands!
•
Food will remain warm thanks to the temperature set.
•
If the device is not to be used for longer periods, turn it off using the ON/OFF
switch at the rear of the device. First, remove the plug from its socket and remove
the power cable from the device.
- 22 -