Kicker PXA.1 Série Manuel D'utilisation page 3

KICKER KISL (optional)
Cut the looped red power cable located on the PXA harness and install a 15A (PXA200.1) or 45A (PXA500.1)
fuse. Fuse installation should be within 18" (45cm) of the battery and in-line with the harness' power cable, which
is connected to your amplifi er. If you ever need to remove the amplifi er from the vehicle after it has been installed,
the ground wire should be the last wire disconnected from the amplifi er--just the opposite as when you installed it.
PXA200.1
bare-metal chassis ground
RCA inputs
(remove to use
hi-level input)
PXA500.1
insert power and
ground terminal
adapter
PXA500.1: Use 8 gauge wire if the
power wire is greater than 10 feet in
length; 10 gauge if less.
2015 PX Mono Amplifiers Rev D.indd 3 2015 PX Mono Amplifiers Rev D.indd 3
to amplifi er
from source unit high-level speaker outputs
≤24"
(60cm)
+
speaker outputs
remote turn-on
bare-metal
chassis
ground
Model
PXA200.1
PXA500.1
external fuse
(15A)
-
remote
turn-on
speaker outputs
-
≤24"
(60cm)
external fuse
(45A)
External Fuse
1 x 15 Ampere
1 x 45 Ampere
≤18"
(45cm)
12V
battery
bare-metal chassis ground
+
≤18"
(45cm)
12V
bare-metal
chassis ground
8/26/2014 3:42:37 PM 8/26/2014 3:42:37 PM
3