AEG FAVORIT 78029 VI0P Notice D'utilisation page 28

28 www.aeg.com
• If the salt indicator is on, fill the salt
container.
• If the rinse aid indicator is on, fill
the rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
7.1 Using the detergent
A
7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when the display shows 2 horizon-
tal status bars. If the control panel does
not show this condition, press RESET.
Starting a programme without
delay start
1. Open the water tap.
2. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode.
3. Press one of the programme buttons
again and again until the display
shows the number of the programme
you want to start.
• The programme number flashes in
the display.
• If you want you can set the applica-
ble options.
4. Close the appliance door, the pro-
gramme starts. The programme du-
ration starts to decrease with steps of
1 minute.
B
30
A
20
+ -
C
• If you use the combi detergent
tablets, activate the Multitab op-
tion.
5. Set and start the correct programme
for the type of load and the degree
of soil.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
Starting a programme with
delay start
1. Set the programme.
2. Press Delay again and again until the
display shows the delay time you
want to set (from 1 to 24 hours).
• The delay time flashes in the dis-
play.
• The Delay indicator comes on.
3. Close the appliance door. The count-
down starts.
• When the countdown is comple-
ted, the programme starts.
Opening the door while the
appliance operates
If you open the door, the appliance
stops. When you close the door, the ap-
pliance continues from the point of inter-
ruption.
Cancelling the delay start
while the countdown operates
When you cancel the delay start, also the
programme is cancelled.
1. Press RESET. The display shows 2
horizontal status bars.
2. Set the programme again.