Fracarro SIG7710 Instructions D'emploi page 37

5.3 SIG7710 WEB MANAGEMENT PROCEDURE
After the preliminary programming by the TPE, the advanced programming will be carried out through
the means of the integrated SIG7710 WEB MANAGEMENT interface. (NOTE: WEB interface could
vary depending on the Firmware version loaded in the module).
The procedure is as follows:
1. From the properties of the PC local network card, modify the IP address, setting a new address
belonging to the same sub-network of the SIG7710 module address set. For example:
a. Parameter set in the streamer
i. IP: 19.168.1.1
ii. SUBNET MASK: 55.55.55.0
b. Parameters to be set in the properties of the network card
i. IP: 19.168.1.
ii. SUBNET MASK: 55.55.55.0
. Connect the PC to the module by means of a cross RJ-45 cable of CAT-5E;
3. Open the Internet browser (Recommended Browser Internet Explorer);
4. Enter the IP associated to the SIG7710 in the address bar; the following HOME PAGE is displayed.
Select the language for the WEB Interface (English, Français, Deutsch, Italian, Espanol, Portugues).
From this menu, the following options can be selected:
HOME --> Initial page of the integrated WEB configuration device;
INPUT --> Input parameters setting and measurement (frequency of the transponder, SAT polarity se-
lection, value of the Symbol rate, S/N and BER values reading, etc.);
PROGRAM LIST --> Display menu and setting menu for SAT programs sent to the network (program
list, definition of IP multicast groups, etc);
MULTICAST --> Setting of the MULTICAST groups;
NETWORK --> Setting of the module IP parameters;
PRESET --> Factory SAT programs settings;
REBOOT --> SIG7710 module restarting (the operation lasts about 15 seconds; during the restart op-
erations, all the LEDs on the front panel are off).
LOGOUT --> Command to exit the WEB Interface management interface.
37