Product Installation - Fracarro SIG7710 Instructions D'emploi

NOTE: For easier headend programming PRESET configurations are available.
ATTENTION: the last pages of these instructions (TECHNICAL SPECIFICATIONS) show the complete
list of characteristics.
The SIG7710 module is installed in the sub-rack of the NewHead Line (SIG7901 or SIG790) series as
per the following photos. Take the module out of its packaging and install it in the wanted position. The
packing contains the following parts:
• SIG7710 module;
• Fast jumper for the interconnection (KPR41);
After the insertion, fix the modu-
le using the screws contained in
the accessory bag.
It's a "plug and play" installation;
therefore, the module is ready to
operate.
To remove the module use the handles included in the New Headline 19" sub-rack.

3. PRODUCT INSTALLATION

Fig. 1
5
Insert the module in the card gui-
des and gently push back to lock
them to the back-panel.
Fig.